Free Headrest · Free Discrete Shipping*

Hiding the Hook: Ceiling Light

While much of the information in this article is still good, it is a few years old. You may be better suited to newer guides on installing a sex swing and just being a proud swing owner.

One of the best places to hide your sex swing hook in your bedroom may be your light fixture. The main advantage of having your hook hidden in the light fixture of your bedroom is that it is located very near the center of your room and may be directly over your bed. This makes it an ideal location for using your swing.

Now before you consider this option for your swing hook, we need to see if this option is good for you. If you have a ceiling fan or a chandelier, this option is probably not for you. What you need is a light with a very large base. Something with a diameter in the range of 12”-20” at the base.

If you do not have a light like this, you can pick one up fairly cheap. I just picked up a new light for this article of about $16 at a local building store.

Lights are fairly easy to install, and there are instructions included with the light.

One of the nice things about installing your sex swing hook in the light is that it is easy to find the joist. If you are replacing the light, you will see an electrical box in your ceiling. This electrical box is almost always nailed into a ceiling joist. This makes it very easy to find where your ceiling joist is. Just look or stick a butter knife around the cut in the dry wall and see if you can identify where the joist is.

Once you have identified where joist is, find a location in the light where you can place the hook that hits the joist, but is also close enough to the center of the light so that the glass cover will fit over it. Most lights are not as deep near the edges, so you will need the hook closer to the center of the light to make sure the cover can go on. Depending on the configuration of your light, you may need to leave one light bulb out or maybe even remove one light bulb when you are using your swing.

Mark the spot on the inside of the light and then remove the light from the ceiling. Drill at ½ inch hole where the hook will go through the light. Do not do this on the ceiling because you want to make sure there are no wires behind where you are drilling the hole.

After you have drilled your hole in the light, reinstall the light and then install the hook. If the hook does not go in far enough to make the cover go on completely, then you may have to cut a larger hole in the light for the base of the hook to set further into the light. Please check this before you install the hook. Make sure the hook will fit. You do not want to install the hook and then find out it does not fit. Removing the hook and reinstalling the hook will make the hold weaker and increase the risk of injury when using your sex swing.

Additional note: When you are working with lights, make sure your power is disconnected at your fuse or circuit breaker box for your safety.

Once the hook is installed and the cover is on, nobody will ever suspect you have a sex swing hook installed in your room.